N 141/31 KNX/DALI Gateway Twin

Communication via KNX EIB with electronic ballasts (ECG) with a DALI interface
Two (2) DALI output acc. to IEC 62386, each for communication with up to 64 DALI ballasts and at least 10 sensors
Integrated power supply with input voltage AC 110…240 V, 50…60 Hz or DC 120…240 V for powering the gateway electronics and DALI output
Maximum DALI output voltage of 19 V, short circuit resistant
Incorrect voltage detection during commissioning, whether incorrect power line is connected to a DALI output
LED display for displaying operation mode and error messages
Pushbutton for switching between bus and direct operating mode
One pair of pushbuttons for switching On/Off of all connected DALI ballasts
One LED per DALI output for status signal of all connected luminaries in direct mode
Configurable behaviour for bus failure (stand-alone mode)
Control (switching, dimming, set dimming value) of all connected luminaries together in broad-cast mode
Status signal and display of lamp and ECG failure per group and per DALI device
One or two level timer
Integrated scene control for up to 32 scenes
Assignment of DALI ECG to groups and test option for ECG, groups and scenes via ETS during commissioning
Possibility to reintegrate defective DALI ECG without software
Integrated bus coupling unit with only half a standard bus load
Bus connection via bus terminal
Mounting on DIN rail EN 60715-TH35-7.5

TÀI LIỆU & HƯỚNG DẪN SỬ DỤNG